Assembling your Dyson light

• Thread the jack plug through the clamp.

• Remove tape from the upright.

• Push the clamp up onto the upright.

• Push the jack plug into the base.

• Fix screw firmly in place using the Hex key provided.

• Fix the clamp using the Hex key provided as shown below.

• Remove the red tape from the mounting plates to expose the electrical contacts.

• Remove red tape on detachable arm.

• Align the square shapes and screw holes on the heat sink arm and the upright.
• Press the two parts together with one hand.

• Loosely screw in the three screws.
• Recheck alignment.
• Proceed to screw until securely clamped.

• Remove red tape on detachable arm and remove transparent tape on upright and weight.

• Back